Skypic 6 recommended electronics


The easiest way to use this list is to right click on each link, then click on "open link in new window" add the item to your cart and close that window which will bring you back here to do the next item on the list


NUTS FOR THE MOTORS (you will need three for each motor, one at the bottom of the shaft then the prop then a nut to tighten the prop down then another nut to lock that one down)

ESC'S X6

KK2 FLIGHT CONTROLLER if you require a kk2 that is preflashed and preprogrammed then click here
MALE TO MALE SERVO LEADS (for connecting your reciver to your flight controller)
USB PROGRAMMING LEAD (you will need this to update your flight controller with the latest firmware)
CLOCKWISE PROPS   These props work fine however in the build video you may notice I have used graupner 11 x 5 
props, this is because they are a more robust prop but cost a lot more money
BULLET CONNECTORS x 2 (you will need these to connect your ESC to your motor)
2 X SERVO EXTENSION LEADS ( For the pitch and roll servos on the gimbal)

You will also need 
  • 6 x 25mm hose clips
  • 12 x m4 x 14mm washers for the props
  • Long nose pliers 
  • Junior hacksaw
  • Selection of screwdrivers
  • Transmitter and receiver
  • Battery charger